Industrial battery repair

BATTERY PREVENTATIVE MAINTENANCE
  • Visually inspect overall condition of batteries (for evidence of over or under filling operating temperatures, corrosion, etc.)
  • Check battery for cracked jars and covers
  • Check electrolyte level, add water as required
  • Inspect for cracked, damaged or missing vent caps
  • Check battery straps, cables and connectors
  • Take voltage readings of all cells in batteries
  • Check specific gravity of representative cells in batteries
  • Provide written recommendations when further repairs or maintenance is required



BATTERY CHARGER PREVENTIVE MAINTENANCE
  • Check D.C. charge rates (start to finish) for battery chargers
  • Inspect charging cables
  • Inspect and validate Ammeter
  • Inspect charging connector
  • Inspect contacts of battery chargers
  • Provide written recommendations when further repairs or maintenance is required



BATTERY REPAIR
  • Replace battery connectors
  • Replace battery cables
  • Replace battery cells
  • Replace battery tar seals
  • Disassemble and reassemble batteries



BATTERY CHARGER REPAIR
  • Change voltage for battery chargers
  • Test and evaluate for battery chargers
  • Replace worn and defective parts of battery chargers
  • Calibration battery chargers



BATTERY AND CHARGER SHOP CONDITIONING
  • Cleaning
  • Charging
  • Acid adjustment
  • Discharge testing
  • Painting
  • Tar resealing
  • Replace parts



ACID ADJUST AND LOAD TEST
Acid adjust the battery before a load test is performed. Acid adjustment ensures that the battery cells are at the manufacturer's recommended specific gravity. Allow three to five days for a normal acid adjust and load test.


BATTERY RESEAL
  1. Battery is washed to remove any loose foreign material, and then the old tar is dug out from in between the cells.
  2. Battery is then neutralized to get rid of exterior acid residue.
  3. Final step is to pour hot tar between the cells and flame the top to insure a good seal.
A normal reseal will last one to two years, depending on cleanliness.


BATTERY AND BATTERY CHARGER CLEANING
(AT CUSTOMER'S LOCATION)

  • Removing corrosion
  • Neutralizing
  • Cleaning cell covers



2108 Candelaria NE
Albuquerque, NM 87107
800-325-7669
Fax: 505-884-9545
sales@rmbattery.com
5165 Vasquez Blvd.
Denver, CO 80216
303-322-9477
fax: 303-322-9466
sales@rmbattery.com
1054 Hawkins Blvd.
El Paso, TX 79915
800-592-1035
Fax: 915-778-3579
sales@rmbattery.com